I. Specification Parameters
|
Product Name |
Model No. |
Rated Voltage |
Rated Frequency |
Rated Power |
|
Hair Dryer Brush |
HB-092 |
220-240V~ |
50/60Hz |
600W |
II. Product Overview
① Anti-Scald Tip
② Brush
③ Air Outlet
④ Handle
⑤ Mode Settings
⑥ Adjustment Knob
⑦ 360° Swivel Cord
III. Instruction for Use
1. Before plugging in, check the voltage on the rating label to make sure it matches your local voltage.
2. The brush is equipped with three settings: low heat and high speed (C), medium heat and low speed (1), and high heat and high speed (2), which can be selected as needed. As a general guide, use high heat and high speed (2) for rough drying for thicker hair, medium heat and low speed (1) for finer and more precise control when styling, and low heat and high speed (C) at the end to set the style. After use, switch the knob to the off position (0).
3. Start with low heat and high speed (C) first to test the optimal temperature for your scalp.
4. Start at the back of the head and work forward when drying your hair.
Note:
1. DO NOT concentrate the airflow on one area for too long.
2. During the first few minutes of initial use, slight smoke and odor may occur. This is normal and will quickly disappear.
IV. Clean and Maintenance
- Always unplug the product and allow it to cool down before cleaning.
- Use soft dry cloth to clean. Do not rinse the product under water.
- Periodically inspect the air intake screen on the rear of the handle and remove the debris that may have accumulated. The debris may reduce air flow and damage the product.
- NEVER use thinner, gasoline alcohols, or any other flammable chemicals to clean the product.
- DO NOT wrap the cord around the appliance, as this may cause wear to the cord.
V. Operating Precautions
⚠ WARNING
Do not use this appliance near bathtubs, showers, basins or other vessels containing water.
- DO NOT touch the brush area during use, as it will become hot.
- NEVER left the product unattended when it is plugged in.
- This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
- Children should be supervised not to play with the appliance.
- DO NOT use the product if any portion of it is chipped or cracked upon visual inspection.
- DO NOT use the product if it is defective or if the power cord is damaged. If the product fails to operate properly, check whether the plug is securely connected and the main power supply is turned on. Do not attempt to repair it by yourself.
- DO NOT use the product in water or other liquids.
- DO NOT use the product near a bathtub, shower, containers full of water, or any other damp place. Never use when hands or feet are wet.
- DO NOT reach for the product if it has fallen in to water. Switch off the power supply at the main breaker, then unplug.
- DO NOT use the product near aerosol cans, spray products or other toiletries.
- Always be careful to avoid burns during use.
- Always unplug the brush when not in use.
- DO NOT use the product for any other purpose than its intended use.
- DO NOT use with a voltage converter.
- Before carrying out any cleaning or maintenance, please be sure the product is unplugged and completely cooled down.
- DO NOT use the product while the air intake filter is removed.
- DO NOT block the air outlet of the product or place the product near or on a soft surface which may block the outlet.
- DO NOT use the product if it has been left outdoors or submerged in water.
-
For additional protection, the installation of a residual current device (RCD) having a ratedresidual operating current not exceeding 30 mA is advisable in the electrical circuit supplying the bathroom. Ask your installer for advice.