ตะกร้าสินค้า
/

SIMPLUS Dehumidifier CUSH009 UserManual

Ⅰ. Product Parameters

Product Name

MODEL NO

Rated Power

Rated Voltage

Rated Frequency

Dehumidifier

CUSH009

90W

220-240V~

50/60Hz

II. Product Illustration

 

A. Front    B. Rear    C. Side    D. Top

  1. Handle
  2. Air Inlet
  3. Water Tank Lid
  4. Transparent Water Tank
  5. Power Cord
  6. Air Outlet
  7. Control Panel
  8. HEPA Filter (Not included in the filter-free version)
  9. Aromatherapy Box

 

III. Operation Instruction

 

Control Panel

Power Button
Temperature Indicator Light

 Humidity Indicator Light

Dehumidification Indicator Light

 

Usage Instruction

  • Connect the power supply and the power button will illuminate.
  • Power on: Press the power button; the dehumidification indicator will illuminate and alternately displays the current ambient humidity and temperature.
  • Sleep mode: Press the power button again, and the device will enter sleep mode. At the same time, the display brightness will decrease and the operating sound will become smaller.
  • Power off: Press the power button again, the display will go out and the dehumidifier will turn off.
  • Drainage: After disconnecting the power supply, take out the transparent water tank and empty the water inside the tank.

   

 

Note:

  1. Do not dismantle the float inside the water tank, otherwise it will cause the water level detection to malfunction, leading to overflow and machine failure.

    

  1. Ensure the water tank is properly installed. If the water tank is not installed correctly, the water level sensor will not work.
  2. Before moving the device, please drain the water in the water tank first. Otherwise, it may lead to water splashing and seeping into the machine, causing damage.
  3. When the water tank is full, the device will automatically turn off, just empty the water tank.

 

 IV. Cleaning and Maintenance

  1. Before cleaning, unplug the power cord and allow the device to cool down.
  2. Please wipe the exterior of the machine with a damp towel and the control panel with a dry towel. Do not submerge the entire unit in water or rinse it under the faucet.
  3. Do not clean with steel wool, abrasive cleaner, or corrosive liquid.
  4. Please allow all product components to dry completely before storing.
  5. Please store the product upright in dry and cool place. Keep away from dust, high temperatures, and direct sunlight.

 

HEPA Filter Cleaning (Filter version)

  1. Remove the water tank, press the built-in push button corresponding to the triangular mark in the middle of the unit, then remove the filter for cleaning when it pops out.
  2. The filter can be washed with water. After washing, it must be completely dried before use.
  3. It is recommended to replace it every 3 to 6 months.

V. Cautions

  1. Before use, ensure the marked voltage matches your local mains supply. Only use the original or manufacturer-specified power cord.
  2. Do not use if the plug, power cord, or product is damaged. Do not disassemble or modify the product yourself. Contact customer service immediately if any problem occurs.
  3. Do not plug or unplug the power cord or operate the device with wet hands.
  4. If smoke, unusual odors, excessive heat, deformation, or other problems occur during operation or charging, immediately disconnect the power and cease use. Contact customer service if necessary.
  5. This product must be used under supervision. Do not leave the device operating unattended. Never tilt or invert the device.
  6. This product is not suitable for use by persons with physical, cognitive, or mental impairments, or those lacking knowledge or experience, including children, unless under the supervision and guidance of a responsible adult.
  7. Do not allow children to play with this product.
  8. Do not open the aromatherapy box.
  9. Do not insert fingers or other objects into the air inlet and outlet.
  10. Do not obstruct the air inlet or outlet.
  11. Do not move or store this device in tilted or inverted position to prevent leakage.
  12. Do not use the water drained from the dehumidifier.
  13. This product must be placed on a level, steady, and heat-resistant surface. Keep away from flammable materials, other heat sources, and humid environments.
  14. It is recommended to use this device in the environment with the  temperature above 5°C.
  15. Please close the doors and windows during the device operation to prevent humid air entering the room and affecting the dehumidification performance.
  16. Please leave about 30cm of ventilation space around the device.
  17. Do not use outdoors. This dehumidifier is only suitable for indoor residential use.
  18. Please drain the water in the tank before moving the device.
  19. Please store the device in an upright position to prevent leakage.
  20. Please use with the Simplus official aromatherapy box. Do not add any type of essential oil.

 

 VI. Common Problem

Common Problem

Possible Reason

Solution

 

The dehumidifier is not working

The water tank is full

Please empty the water tank and reinsert it into the dehumidifier

The float in the water tank is stuck

Please press the float in the water tank, then place the tank back into the dehumidifier

The machine is not powered on

Please check that the power cord is properly plugged in

The air outlet is blocked

Please leave about 30cm of ventilation space around the device

The dehumidifier is making abnormal noise

The machine is not placed on a level surface

Please place the machine on a level surface

The air outlet is blocked

Please clean the air inlet and outlet

The dehumidification effect is not good

Airflow obstruction

Please leave about 30cm of ventilation space around the device

The air inlet and outlet are blocked

Please clean the air inlet and outlet

The HEPA filter has not been cleaned for a long time, resulting in poor filter

Please clean the HEPA filter. 

The air humidity is too low

This is normal

There is a deviation between the display and the external temperature and humidity

The data displayed by the machine are the purified air inside the machine, so it may lower than actual temperature and humidity.

This is normal